Table of Contents
Advertisement
Recalling a Register
Use the numeric keypad control block to recall a register.
For each region there are 99 registers dedicated to
keyframes, numbered from 1 to 99.
When creating an effect as a user programmable DME, use
a 3-digit register number which is commonly used for all
DME regions (channels).
For details about regions and registers, see "Regions"
(page 275) and "Registers" (page 276).
Recalling a Register (Numeric
Keypad Control Block)
EFF button
Region selection buttons
Numeric keypad control block
Region selection in the numeric keypad control
block
Select the target region using the following region
selection buttons.
[M/E1] to [M/E5], [P/P]: M/E-1 to M/E-5, PGM/PST
regions
[USER1] to [USER8]: User regions
[DME1] to [DME4]: DME channels
[DEV1] to [DEV12]: Devices
[PBUS]: P-Bus
[GPI]: GPI
[MCRO]: Macro
[RTR]: Router
[ALL]: Select all regions at the same time
EFF DISS button
Display
Numeric keypad buttons
UNDO button
RCALL button
[MASTR]: Master timeline / master snapshot
You can select more than one region. The first selected
button becomes the reference region, and is lit green.
Subsequent selected buttons are lit amber.
Pressing one of the amber-lit region selection buttons,
while holding down [EFF] or [SNAPSHOT], turns the
button green to indicate its corresponding region as the
new reference region.
When [ALL] is selected or a selected reference region is
released, the reference regions will be set according to the
precedence order.
For details about the precedence order for reference
regions, see "Reference region" (page 275).
The display shows the selected region name. The reference
region is displayed highlighted. If multiple regions are
assigned to a green-lit button, an asterisk (*) will appear on
the left side of the region name.
Notes
• The regions that can be selected simultaneously are
those assigned to the region selection buttons in the
numeric keypad control block.
• It is not possible to select the master timeline and other
regions simultaneously. If selected simultaneously, the
master timeline takes precedence.
• For region selection buttons that not set by default,
assignment is required in the Setup menu. Up to four
regions can be assigned to a button.
• The regions that can be selected will differ depending on
the function (see page 275).
• The regions that are selected when [ALL] is pressed are
set in the Setup menu (see page 375).
• When [ALL] is pressed while no region is selected, all
regions that are currently set will be selected. When
[ALL] is pressed while regions are selected, all the
selected regions will be deselected.
Register selection in the numeric keypad control
block
Enter the register number using the numeric keypad
buttons.
The display shows the selected register number and the
following information.
e: The selected register is empty for the currently selected
region.
E: The selected register is empty for all selectable regions.
L: The selected register is locked.
To search for an empty register without specifying a
register number, press the [.] (period) numeric keypad
button.
To search for an empty register common to all selectable
regions, press the [.] button again.
285
Advertisement
Table of Contents
