Table of Contents
Advertisement
e SPARE 1 to 4 connectors (BNC type: XKS-S8165,
RJ-45 type: XKS-T8165)
From left to right, the same signals as on the FC
OUTPUT1, 5, 9, and 13 connectors are output.
f MV (multi viewer) OUTPUT 1 to 8 connectors
(BNC type: XKS-S8165, RJ-45 type: XKS-T8165)
Multiple output signals can be combined and output as
serial digital video signals arranged in a grid. Up to two
output systems are supported. The output setting is
controlled from the control panel of the XVS system.
g U (signal ground) terminal
Connect to the system ground.
h MVS LAN (multi format video switcher LAN)
connector (RJ-45 compliant)
Connect to an Ethernet switch.
Used to communicate between switcher control stations
connected to an Ethernet switch.
1) For details about supported Ethernet switches, contact your Sony service
or sales representative.
For details about Ethernet switch connection, refer to the XVS-8000
Installation Manual.
i UTL LAN (utility LAN) connector (RJ-45
compliant)
Reserved for future use.
Do not connect any signal to this connector.
j RESET CIRCUIT BREAKER button
If an overcurrent condition is detected, due to a short
circuit or other cause, the button will pop out,
disconnecting the circuit. The button pops out approximate
5
3.5 mm (
/
inches).
32
k -AC IN (AC power input) A, B, C, and D
connectors (3-pin)
Connect to 100 V to 240 V AC power supply with AC
power cords (sold separately).
l REF IN (reference video signal input) connectors
(BNC type)
Connect to an HD tri-level sync signal, black burst signal,
or analog sync signal when using the unit synchronized to
an external sync signal.
The two connectors are loop-through, so that the signal
input on either connector is also output on the other
connector. Connect the supplied 75 Ω terminator to the
remaining connector if not using the loop-through output.
1)
62
Advertisement
Table of Contents
