Making Settings Required To Use The Software - Sony MVS-8000 User Manual

7
8
9

Making Settings Required to Use the Software

To use the software listed below, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
BZS-8250
BZDM-9050
BZS-8050
BZS-8200
BZS-8420
BZS-8500M
BZS-8510M
BZS-8520M
BZS-8530M
BZS-8560
BZDM-8560
a) This can be used only with a CCP-9000A series control panel.
b) This can be used only on the MVS-8000G.
c) This can be used only on the MVS-8000GSF.
d) This can be used only on the MVS-8000G/GSF.
e) This can be used only on the MVE-8000A.
To display the unique device ID
1
36
Installation and Device Setup (Install/Unit Config Menu)
Repeat steps 3 to 6, to confirm all software to be installed.
Press [Execute].
A confirmation message appears.
Press [Yes].
This carries out the installation, and when it completes normally, the
"Install" box shows "OK."
Simple P/P Software
Texture Lighting Software (for MVE-9000)
Editing Control Software
Multi Program 2 Software
Color Corrector Software
Switcher Upgrade Software
Switcher Upgrade Software
Mix/Effect Upgrade Software
Mix/Effect Upgrade Software
Switcher Upgrade Software
DME Upgrade Software
In the System >Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
a)
d)
b)
c)
d)
b)
b)
e)