Table of Contents
Advertisement
5. Prime the Grease Gun by pumping the handle a few times until grease is seen to exit the
tube.
6. Insert the tube through the access holes to touch the Drive Screw directly.
7. Apply a generous dab of grease (two strokes of the handle or approximately 1/14 of the
cartridge) onto the Drive Screw.
8. Jog the mast about ¾ inch (19 mm) (one half revolution of the Drive Screw) and apply
another generous dab (two strokes of the handle or approximately 1/14 of the cartridge).
It is not necessary to use an entire cartridge of grease during a single maintenance
procedure. The cartridge should last for seven greasing operations.
9. Replace the access plug into the access plate. Screw the hydraulic coupling (cap) back
onto the output tube of the Grease Gun.
10. Retract the mast completely, extend it completely and retract it completely to distribute
the grease over all the Extension Nuts and the complete Drive Screw.
11. Record the date, cycle count, and procedure in the mast's maintenance record.
TP-5418901-F
August 2020
S
TILETTO
Original Instructions
AL O
I
PERATING
NSTRUCTIONS
5-7
Advertisement
Table of Contents
