Table of Contents
Advertisement
5.2 Maintenance Equipment
Table 5-1 lists recommended equipment for maintenance.
Personal Protective
Safety Glasses
Hearing Protection
Hand Tools
Paint Brushes
Wire Brush
Equipment
Grease Gun
Expendables
Denatured Alcohol or Other
Solvent
Rags (Soft, Clean, and Dry)
* Note:
•
Depending on the local, regional, and national standards and codes of practice, and the environment,
additional personal protective equipment may be necessary.
•
When disposing of any disposables or components, do so according to any applicable local, regional, and
national standards and codes of practice.
5.3 Spare Parts
To order spare or replacement parts, always refer to the mast model number and serial number.
The model number, serial number, and additional information is engraved on the mast
Identification Plate (Section 1.7.1.11). Throughout this manual, "P/N" followed by a number
represent the part number for that component. To order spare parts, or for the part numbers for
additional components, contact The Will-Burt Company.
5.4 Preventative Maintenance Checks and Services (PMCS)
This section describes the systematic care, inspection, and servicing of equipment to keep it in
good condition and to prevent breakdowns. If the Mast System does not perform as required,
see Section 8. If anything looks wrong and cannot be diagnosed and/or fixed, the Mast System
should be taken to the next higher level maintenance facility. The Will-Burt Company
recommends creating and maintaining a maintenance log for each Mast System.
TP-5418901-F
August 2020
Table 5-1 Equipment Recommended for Maintenance
Recommended Equipment*
Work Gloves
Hard Hat or Helmet
Screwdrivers
Wrenches
Hoist
Drive Screw Lubricant
(P/N: 4288601)
Touchup Paint
Original Instructions
S
AL O
TILETTO
PERATING
Nitrile or Vinyl Gloves
Safety Shoes
Torque Wrench
Sling
Non-Abrasive Cleaners
(Soap and Water)
I
NSTRUCTIONS
5-3
Advertisement
Table of Contents
