Table of Contents
Advertisement
S
AL O
TILETTO
PERATING
2.6 Mast System Installation
This section describes installation of the Mast System, assuming an external mounting
application. For internal mounting applications (i.e. mounting inside an enclosure or vehicle),
The Will-Burt Company recommends:
•
Using a Roof Seal Kit (P/N: 4794602)
•
Using a ½-14 NPT brass nipple and a hose to route water from the Mast System outside
the enclosure
For additional information, please see the Stiletto Series Roof Seal Kit Installation Instructions
(TP-5532101). If necessary, contact The Will-Burt Company to obtain these instructions.
2.6.1 Installation Quick Summary
The following is a quick summary of installation of the Mast System. Detailed steps follow the
quick summary (Section 2.6.2).
In general, install the Mast System as follows:
1. Select a Suitable Mounting Location (Section 2.6.2.1)
2. Unpack the Mast System (Section 2.6.2.2)
3. Secure the Support Bracket Assembly (Section 2.6.2.3)
4. Secure the Base of the Mast (Section 2.6.2.4)
5. Finalize Physical Installation of the Mast (Section 2.6.2.5)
6. Install the Universal Control Box (Section 2.6.2.6)
7. Electrically Install the Mast System (Section 2.6.2.7)
8. Connect Power to the Mast System (Section 2.6.2.8)
2.6.2 Installation Detailed Instructions
The following are detailed steps describing the installation of the Mast System. The exact
installation procedures may vary based on the configuration of the Mast System being used and
the installation environment.
These instructions assume that the mounting hole locations are not pre-drilled and that the Mast
System components will be used as templates to drill these holes during installation.
Alternatively, the mounting hole locations could be found and pre-drilled using the installation
dimensions (Section 0). When pre-drilling the mounting holes, use care to ensure the mounting
holes properly align.
2-12
I
NSTRUCTIONS
Original Instructions
TP-5418901-F
August 2020
Advertisement
Table of Contents
