Select a Suitable Mounting Location
To select a suitable mounting location, consider the following:
•
The mounting structure must have sufficient room to mount the system. Ensure the
installation site does not interfere with the cables or crowd them into the mast where
during retraction they can be pinched between collars or speared by trigger posts.
•
The mounting structure must be level in all directions, solid, and capable of holding the
forces required by the bolts. Check the strength and rigidity of the mounting structure
where the system is to be attached. Reinforce as necessary. The support bracket and
base support structure shall be mounted to a common frame (i.e. not separated by
vehicle suspension elements)
•
The area underneath the mast must be free of obstructions to allow for accessibility to
the fasteners.
•
Do not obstruct the Drain Hole (Figure 2-4) for rainwater and condensation at the base
of the mast. Keep any personnel or sensitive equipment away from the Drain Hole
direction.
Drain Hole
•
Cables will eventually need routed between components of the system as follows:
o Customer power to the Universal Control Box
o The three meter Motor and Brake Cable and the three meter Mast Sensor Cable
will need routed between the Universal Control Box and mast
o Additional cables may need routed for optional components
TP-5418901-F
August 2020
S
Figure 2-4 Drain Hole Location
Original Instructions
AL O
TILETTO
PERATING
Drain Hole
I
NSTRUCTIONS
2-13