Additional Accessory Installation; Figure 2-12 Flat Spots On Collars - Will Burt Stiletto AL 4-Meter Operating Instructions Manual

2.7 Additional Accessory Installation

Depending on the configuration of the Mast System, optional components selected, or the
installation environment, additional accessories such as PC Interface, Capacitor Bank, or
positioners may need to be installed. Install any additional accessories as appropriate.
General installation procedures to keep in mind when installing optional accessories include:
•
Use connector J4 on the Universal Control Box to connect the following optional
components:
o D-TEC
o Hand-Held Remote Control (HHRC)
o PC Interface
Note: Will-Burt offers an adaptor Y-Cable to allow for the use of both the PC Interface
and an HHRC.
•
Each collar on the Mast System has four flat spots with two M6 holes for components
such as Nycoils or intermediate antennas to attach (Figure 2-12).
Contact The Will-Burt Company with any questions before performing any installation
procedures.
TP-5418901-F
August 2020

Figure 2-12 Flat Spots on Collars

Original Instructions
S AL O
TILETTO PERATING
I
NSTRUCTIONS
Flat Spot
with M6
Holes
2-23