Will Burt Stiletto AL 4-Meter Operating Instructions Manual page 106

S AL O
TILETTO PERATING
Error Trigger
Code Condition
1000 CAN Output
Buffer Overflow
2000 CAN Input
Buffer Overflow
8000 Firmware Error
L.S. Both Limit
ERR Switches are
(Legacy)
seen as active.
8-8
I
NSTRUCTIONS
Table 7-2 Error (Fault) Codes Continued
System Response
CAN Output Buffer
Overflow (ERR 1000):
CAN bus failure. Check
CAN bus connections.
CAN Input Buffer
Overflow (ERR 2000):
CAN bus failure. Check
CAN bus connections.
User Input Error
(ERR 8000):
Refer to product
documentation for valid
commands.
Limit Switch Error
Disable the Motor Outputs
unless the OVERRIDE
Switch is also active.
Original Instructions
Latch Until Possible Cause
• System power
CAN Bus cannot be
written to as queued
is cycled and
information has not been
trigger
sent.
conditions
cleared
• System power
External source has
written CAN buffer and we
is cycled and
have not retrieved the
trigger
data, so currently
conditions
incoming CAN data
cleared
cannot be received.
• 5 OVERRIDE • Erroneous user input in
Switch the text user interface
activations during debug mode.
within 3
seconds
- or -
• System power
is cycled and
trigger
conditions
cleared
• Cannot be • If the mast is nested, a
cleared until magnet may be near
the condition the extended limit
causing the switch.
error is fixed.
• If the mast is extended,
Use the
a magnet may be near
OVERRIDE
the nested limit switch.
Switch for
• Wiring damage
emergency
operation.
• Connector damage
• Switch damage
TP-5418901-F
August 2020