Will Burt Stiletto AL 4-Meter Operating Instructions Manual page 110

S AL O
TILETTO PERATING
Warning Trigger
Code Condition
0040 Extend/Retract
(Legacy) movement (50
mm) not
detected after
2 seconds of
continuous
extend/retract
command
0080 Extend/Retract
(Legacy) movement (50
mm) not
detected after
2 seconds of
continuous
extend/retract
command
8-12
I
NSTRUCTIONS
Table 7-3 Warning Codes Continued
System Response
String
Potentiometer
Failure Warning
(WRN 0040):
Allow all normal
mast functions.
NOTICE:
Mast height readout
will be inaccurate.
Encoder Failure
Warning
(WRN 0080):
Allow all normal
mast functions.
NOTICE:
Mast height readout
will be inaccurate.
Original Instructions
Latch Until Possible Cause
• Valid signal • If seen in current
detected control boxes, it
likely means the DIP
- or -
switches in the
• 5 OVERRIDE
circuit board are set
Switch
incorrectly.
activations
within 3
• Potentiometer
seconds
requires adjustment
- or -
or recalibration
• System power
• Potentiometer failed
is cycled and
and requires
trigger
replacement
conditions
cleared • Potentiometer wiring
damaged and
requires repairs or
replacement
• Valid signal • If seen in current
detected control boxes, it
likes means the DIP
- or -
switches in the
• 5 OVERRIDE
circuit board are set
Switch
incorrectly.
activations
within 3
• Encoder requires
seconds
adjustment or
- or -
recalibration
• System power
• Encoder failed and
is cycled and
requires
trigger
replacement
conditions
• Encoder wiring
cleared
damaged and
requires repairs or
replacement
- Legacy -
- Legacy -
TP-5418901-F
August 2020