Figure 2-13 Mounting Hole Pattern - Will Burt Stiletto AL 4-Meter Operating Instructions Manual

S AL O
TILETTO PERATING
3. Properly secure the payload to the mast with customer-provided M8 high strength
hardware. Choose the appropriate length of screw in order to allow maximum thread
engagement with the threaded inserts. The standard Payload Interface has six M8x1.25
– 6H ↧12mm holes (Figure 2-13). If required, the Ø6 ↧ 10.0 hole may be used for
orientation. The mounting hardware must include proper means to resist vibration
loosening such as thread-locking compound and/or locking hardware. Torque all
hardware as appropriate for its size and grade.
The six Ø8.2 thru holes on the side of the payload mount can be used for additional M8
bolts, quick release pins or a tether for additional payload security. These holes are
oriented 30° from the bolt pattern on the top of the payload mount and are at a height of
0.5 inches below the top payload mount surface. Please contact Will-Burt Engineering to
determine if your application requires these precautions.
Note: The Payload Interface has stainless steel inserts. When using stainless steel
hardware, use an anti-seize to prevent galling. Use vibration locking methods that do not
rely on thread locking compound when using anti-seize.
One Ø6 ↧ 10.0 Hole on a
110mm Bolt Circle Diameter
Figure 2-13 Mounting Hole Pattern (Payload Interface for 6-Meter Stiletto AL P/N: 711990692 Shown)
Contact the factory for alternatives to the depicted interface.
2-26
I
NSTRUCTIONS
Original Instructions
Six M8x1.25 – 6H ↧12mm
Holes Equally Spaced on a
Ø110 mm Bolt Circle Diameter
TP-5418901-F
August 2020