Table of Contents
Advertisement
S
AL O
I
TILETTO
PERATING
NSTRUCTIONS
Safety Instruction – Observe Proper Lifting Procedures! Use extreme caution while lifting
the Mast System and when Mast System is suspended to avoid injury and equipment damage.
Be certain the Mast System is properly secured. All operators should be aware of and follow the
applicable local, regional, and national standards and codes of practice for slinging and
transporting equipment. Never lift Mast System over people. Ensure lifting equipment including,
but not limited to, lifting straps and hoist, are capable of handling the forces generated from
lifting the system. Observe manufacturer instructions on lifting equipment. Death or serious
injury could result if proper procedures are not followed.
Safety Instruction – Operation! For outdoor use only. Do not use in areas that have been
classified as hazardous as defined in Article 500 of the National Electric Code.
Safety Instruction – Potential Air Contaminants! If internally mounted in a vehicle, air from
the mast and any accumulated water will discharge into the vehicle. Appropriate drainage
location shall be defined by the installer.
Disconnect Power! Power must be disconnected before connecting or disconnecting any Mast
System connector. For example, power must be disconnected when connecting or
disconnecting J1, J2, J3, and J4 on the Control Box. Do not disconnect the power cable from J1
on the Control Box or from the power source while the mast is in motion (extending or
retracting). This could result in damage to the Control Box.
Equipment Damage – Control Box! Do not open the Universal Control Box. The Universal
Control Box is vacuum-sealed at the factory. Opening the Universal Control Box could cause
equipment damage and will void the warranty.
Equipment Damage – Forces! Before unloading the system, be certain the unloading region is
capable of resisting forces generated from unloading the system including but not limited to
system weight. Ensure the unloading region is level and has sufficient room and strength to hold
the system. If the unloading region is incapable of meeting the requirements of the system,
damage to the system and/or unloading region could occur.
Equipment Damage – Qualified Personnel! All persons installing and maintaining this
equipment should be suitably qualified and work to local, regional, and national standards and
codes of practice.
Equipment Damage – Support Bracket! Do not overtighten the mast support bracket.
Overtightening may damage the Base Tube causing the mast tubes to stick.
x
Original Instructions
TP-5418901-F
August 2020
Advertisement
Table of Contents
