Section 9 Reference; Extended Glossary Of Terms; General Terms And Abbreviations - Will Burt Stiletto AL 4-Meter Operating Instructions Manual

Section 9
This section provides reference information for the system as follows:
•
Extended Glossary of Terms (Section 9.1)
•
Guying (Section 9.2)
•
Drawings (Section 9.3)

9.1 Extended Glossary of Terms

This section defines terms used within this manual as follows:
•
General Terms and Abbreviations (Section 9.1.1)
•
Mounting Position Terms (Section 9.1.2)

9.1.1 General Terms and Abbreviations

This section describes general terms and abbreviations used within this manual.
•
"Amp" stands for ampere which is a unit of electric current
•
"Base Tube" refers to the tube with the largest diameter. When the mast is fully
extended, this is the tube closest to the mounting surface.
•
"CD" stands for coefficient of drag.
•
"Collars" attach to the top of each tube except the Top Tube.
•
"EMC" stands for electromagnetic compatibility.
•
"EMI" stands for electromagnetic interference.
•
"Extended" refers to the partial- or full-raised position of the mast that the mast
mechancially goes to from the nested position. In the extended position, some or all the
tubes have risen.
•
"ID" stands for Inside Diameter or the diameter to the inside edge of a circle
•
"in.-lb." stands for inch-pounds, which is a unit of torque equal to the force in pounds
multiplied by the distance in inches to the pivot point
•
"Intermediate Tubes" refer to the tubes between the Base Tube and the Top Tube.
•
"lb.-ft." stands for pounds-feet, which is a unit of torque equal to the force in pounds
multiplied by the distance in feet to the pivot point
•
"Mast" to refer to the mechanical telescoping mast
•
"Mast System" to refer to the entire Stiletto AL Mast System (Telescoping Mast,
Universal Control System, and additional accessories)
TP-5418901-F
August 2020
Reference
Original Instructions
S AL O
TILETTO PERATING
I
NSTRUCTIONS
9-1