Table of Contents
Advertisement
Section 5
This section describes maintenance procedures required to keep the system operational. Use
care to understand and follow all precautions while performing these procedures.
Disconnect power to the mast system and any devices mounted to the mast with lock out tag
out procedures as appropriate before performing mast maintenance. The J1 connector on the
Universal Control Box can be removed to isolate power to the mast and control box. Be sure
source power is removed before removing the J1 connector.
5.1 Pre-Maintenance Check
Before performing maintenance procedures, ensure:
•
All operators read and understand the entire maintenance procedure and are properly
trained.
•
The payload is removed prior to performing maintenance on the system.
•
The system is level and secure.
•
The following precautions are understood and followed:
Trained Personnel Only! Only trained and qualified personnel should perform maintenance
and servicing procedures. Only a properly trained and qualified certified electrician should
perform electric maintenance and service. Death or serious injury could result if proper
maintenance procedures and inspections are not observed.
Tip Over Hazard! Before performing maintenance or repair, ensure the Mast System is level
and secure. Injury to personnel or equipment damage could occur if the Mast System tips over.
Health and Safety Hazard! Solvent used to clean parts is potentially dangerous. Follow solvent
manufacturer's safety procedures and recommendations. Avoid inhalation of fumes and also
prolonged contact to skin. Death or serious injury could occur if solvents are not handled
properly.
Fire Hazard! Do not smoke. Use cleaning solvent in a well-ventilated area. Keep cleaning
solvent away from ignition sources including open flame, arcing equipment, heaters, and
excessive heat. Always store cleaning solvent in the proper marked container. Cleaning solvent,
used for maintenance, is flammable and can be explosive resulting in death or serious injury.
TP-5418901-F
August 2020
Maintenance
Original Instructions
S
AL O
TILETTO
PERATING
I
NSTRUCTIONS
5-1
Advertisement
Table of Contents
