Installation Procedure - Mitsubishi Electric GOT SIMPLE Series User Manual

6.5

Installation Procedure

The GOT is designed to be embedded into a panel. Mount the GOT by following the procedure below.
Refer to Page 48 Panel Cutting Dimensions for the panel cutting dimensions.
In addition, the thickness of the installation panel face must be 1.6 to 4mm.
Mounting hole
Mounting
screw
Check that the packing is firmly attached with the GOT.
If the packing is loose, attach the packing to the GOT securely.
1.
Inserting into the panel face
Insert the GOT from the front side of the panel.
2.
Fixing the GOT
Engage the hook of the mounting fixture (accessory) to the unit fixing hole of the
GOT and fix them by tightening the mounting screws (accessory) in the torque
range of 0.36 to 0.48N·m.
Mounting
fitting
3.
A protection film is attached on the display section of GOT prior to shipment.
Remove the film when the installation is completed.
6 INSTALLATION
6.5 Installation Procedure
6
51