Mitsubishi Electric GOT SIMPLE Series User Manual page 38

Parts names of the back panel
No. Name
(1) RS-232 interface
(2) RS-422/485 interface
(3) RS-422 interface
(4) Ethernet interface
(5) USB interface (Device)
(6) Hole for preventing the USB cable from unplugging
(7) Terminating resistor setting switch
(8) Rating plate
(9) SD card interface
(10) SD card access LED
(11) Vertical installation arrow mark
(12) Power terminal
(13) Ethernet communication status LED
4 PART NAME
36
4.2 Back Panel
Specifications
For communicating with controller (PLC, microcomputer board, RFID, etc) or personal
computer (OS installation, project data download, FA transparent) (D-sub 9-pin male)
For communicating with controller (PLC, microcomputer board, etc) (D-sub 9-pin female)
For communicating with controller (PLC, microcomputer board, etc) (D-sub 9-pin female)
For Ethernet communication with controller (PLC, microcomputer board, etc) (RJ-45
connector)
USB interface for data transfer and saving
Hole for preventing the USB cable from unplugging with a banding band
For switching the terminating resistor setting of the RS-422/485 communication port to
330 Ω, 110 Ω, or OPEN
Model name, current consumption, production number, hardware version, and Boot OS
version are described.
Interface for mounting an SD card to the GOT
ON: SD card is accessed, OFF: SD card is not accessed
For the vertical installation, install the GOT so that the arrow points upward.
Power terminal and FG terminal (for power supply (24VDC) to GOT and grounding)
SD RD: Green light while data are being sent or received, 100M: Green light when the
transmission speed is 100Mbps