Writing Commands - Mitsubishi Electric GOT SIMPLE Series User Manual

Writing commands

Writes a sequence program to the FX PLC. (Overwrite/Insert)
Writing basic commands
■Operations
Inputting command only (Ex.: ANB, ORB command etc.)
Stop the FX PLC
MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
Inputting command and device (LD, AND commands etc.)
Stop the FX PLC MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
Input the device name and device number
Inputting command, No. 1 device, No. 2 device (MC, OUT (T, C) commands, etc.)
Stop the FX PLC MODE
For overwriting: (WRITE mode)
For insertion: (INSERT mode)
Input the device name and device number
SP
Moving the cursor to the position to write the command
When starting to write a command, place the cursor on the command line (the line on which the step number
is displayed).
You cannot write a command with the cursor on an operand or set value line.
2 LDI
3 MOV
Input the command
GO
Input the command
GO
Input the command Input the device name and device number
GO
M 100
Command line (Place the cursor on this line.)
12
D 0
Operand, set value line (Cannot operate on this line.)
D 10
16 GOT SELF CHECK (DEBUG)
16.2 FX List Editor
16
245