Table of Contents
Advertisement
– Loosen bolt -arrow- for sprockets about 1 full turn. To do this,
counterhold vibration damper using counterhold - T10172- .
– Fix chain tensioner spring using 3 mm Allan key -A-.
– Remove chain tensioner for oil pump drive chain -arrows-.
– Remove sprockets together with timing chain from oil pump.
Installing:
– Set crankshaft to TDC position.
•
Ground tooth of drive sprocket -arrow- must align with bearing
joint.
– Now turn oil pump shaft -1- with flat side -arrow- horizontal to
mark -2- on oil pump.
– Insert timing chain into guide rail and place on crankshaft.
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
95
3. Chain drive
Advertisement
Table of Contents
