Table of Contents
Advertisement
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
– Renew assembly mounting bolts -arrows- in succession (if not
already carried out on installing engine) and screw in hand-
tight.
Align engine bracket: There must be a distance -a- of at least
10 mm between engine support and right longitudinal member.
The cast edge on the engine support -2- must be aligned parallel
to the support arm -1- (distance -x- must be identical at front and
rear).
– Tighten bolts for engine mounting. Specified torques
⇒ page 21
.
Adjusting gearbox mountings:
– Renew gearbox mounting bolts -arrows- in succession (if not
already carried out when installing the engine) and screw in
hand-tight.
– On gearbox side, ensure that edges of support arm -1- and
gearbox mounting -2- are parallel.
•
Dimension -x- must be identical on both sides of mounting.
– Tighten bolts for gearbox mounting. Specified torques
⇒ page 21
.
Further installation is carried out in the reverse sequence.
26
Rep. gr.10 - Removing and installing engine
Advertisement
Table of Contents
