Table of Contents
Advertisement
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
– Ensure that dowel sleeves are inserted in the cylinder block in
bores 12 and 20.
– Apply a 2 mm thick bead of sealant - D 176 501 A1- onto joint
between cylinder block and sealing flange as shown
-arrows-.
Note
Do not remove new cylinder head gasket from packaging until
♦
it is ready to be fitted.
Handle new gasket very carefully. Damage will cause leakage.
♦
– Fit the new cylinder head gasket immediately. Inscription (Part
No.) must be readable.
– Additionally insert a little sealant - D 176 501 A1- into the two
3 mm bores which lie on the sealant bead.
– Set camshafts in cylinder head to TDC for No. 1 cylinder .
Cams -A- of cylinder 1 must face each other.
– Camshaft bar -T10068 A- must engage in grooves in both
shafts.
– Fit cylinder head.
66
Rep. gr.15 - Cylinder head, valve gear
Advertisement
Table of Contents
