Table of Contents
Advertisement
❑ Before installing valve timing housing, check strainer for soiling
❑ Removing and installing
7 - 8 Nm + turn 180° further
❑ Renew
8 - Exhaust camshaft adjuster
❑ Identification: 32A.
❑ Only rotate engine when camshaft adjuster is installed and chain is fitted
❑ Installing
⇒ page 105
9 - Inlet camshaft adjuster
❑ Identification: 24E
❑ Only rotate engine when camshaft adjuster is installed and chain is fitted
❑ Installing
⇒ page 105
1
10 - 60 Nm +
/ 4 turn (90°) further
❑ Renew
❑ Contact surface of sender wheel must be dry around bolt head when installed.
❑ To remove and install, counterhold using 27 mm open-end spanner on camshaft
and installing camshafts.
11 - Cylinder head height
❑ Minimum height: a = 139.9 mm.
12 - Drive sprocket for high pressure pump
❑ With inner splines
❑ Bearing shaft fits in only one position
13 - Bearing shaft
❑ Bearing shaft fits in only one position
❑ Coat bearing shaft with grease - G 052 723 A2-
❑ Vacuum pump drive shaft
14 - Valves
❑ Exhaust valve with sodium filling
❑ Do not rework; only lapping-in is permitted.
❑ Valve dimensions
15 - Dowel sleeve
16 - Cylinder head
❑ Check for distortion
❑ Removing and installing
❑ Reworking valve seats
❑ After renewing, renew entire coolant.
17 - Pump plunger
❑ Note installation position
18 - Support element
❑ Before installing, check camshaft axial clearance
❑ Do not interchange
❑ With hydraulic valve clearance compensation.
19 - Valve stem seal
❑ Renewing
⇒ page 116
20 - Camshaft timing chain
❑ Before removing, mark direction of rotation (installation position).
❑ Removing and installing
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
⇒ page 101
⇒ page 121
⇒ page 60
.
⇒ page 60
⇒ page 197
⇒ page 83
⇒ page 80
⇒ page 100
.
⇒ page 101
, Removing
99
4. Valve gear
Advertisement
Table of Contents
