Cylinder Block, Gearbox End; Assembly Overview - Cylinder Block, Gearbox End; Removing And Installing Flywheel - Volkswagen CC 2012 Workshop Manual

CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
2

Cylinder block, gearbox end

⇒ "2.1 Assembly overview - cylinder block, gearbox end",
page 36
⇒ "2.2 Removing and installing flywheel", page 36
⇒ "2.3 Renewing crankshaft oil seal (gearbox end)", page 37
2.1

Assembly overview - cylinder block, gearbox end

1 - Cylinder block
❑ Crankshaft
⇒ page 40 .
❑ Dismantling and assem‐
bling pistons and con‐
rods ⇒ page 51
2 - Dowel pin
3 - Cover for timing chain
❑ Removing and installing
⇒ page 75
4 - Bolt
❑ 60 Nm +
1
/ 4 turn (90°)
further
❑ Renew
❑ To loosen or tighten,
use counterhold -
T10044- (with 5 mm
spacers) or counterhold
- T10172- .
5 - Flywheel
❑ Removing and installing
⇒ page 36
6 - Needle bearing
❑ Renew
❑ Removing and installing
⇒ page 42
7 - Sealing ring
❑ Remove using extractor
hook - T20143/2-
❑ PTFE-type oil seal
Identification: Without
garter spring
❑ Do not additionally oil or grease the oil seal sealing lip.
❑ Before installing, remove oil residue from crankshaft journal using a clean cloth.
❑ Removing and installing
8 - Centring sleeve
2.2

Removing and installing flywheel

Special tools and workshop equipment required
36
Rep. gr.13 - Crankshaft group
⇒ page 37