Window Contacts (Accessory): "Teach In" Process And Installation - oventrop R-Tronic RT B Installation And Operating Instructions Manual

4.8 Window contacts (accessory):
"Teach in" process and installation
The wireless thermostat "R-Tronic" has to be mains operated for use of
window contacts.
Wireless window contacts (type "FK-C F" item no. 1153070)
allow for an automatic control of the wireless actuators which
have been adapted to the "R-Tronic". As soon as a window is
tilted or opened completely, the wireless contact will transmit a
signal to the wireless thermostat "R-Tronic" to close all "teached
in" actuators (in the room). This will take some time. The
wireless actuators will continue control operation as soon as all
windows are closed again.
A window contact set consists of a wireless sensor
module (1) and a magnet (2). A solar panel (1b)
supplies voltage to the module. For this reason, the
window contacts should not be installed in rooms with
little or no solar radiation.
1 Wireless sensor module
1a Notch
1b Solar panel
1c Adhesive strip for fixing at the window casing
1d "Teach in" button (recessed)
2 Magnet
2a Notches
Depending on the lighting in the room, the wireless window contacts may
require 2 to 3 days to build up a basic charge after initial installation.
Each window contact has to be adapted
to the "R-Tronic".
Steps 1-4 described under paragraph
4.6.2 need to be performed at the
operating unit "R-Tronic" for this
purpose.
A running countdown of 30 seconds
will be displayed (TEACH MODE).
Installation and initial operation
- 26 von 64 -
Illustr. 19
1 1
b a
2
a
1
2
Front Reverse
side side
Illustr. 20
1
c
1
d