Date And Time - oventrop R-Tronic RT B Installation And Operating Instructions Manual

2. Turn the menu-button slightly to the right and confirm the selection TEACH OUT.
As for the "teach in" process, a running countdown of 30 seconds will be
displayed.
3. Now the "teach in"/adjustment button at the actuator has to be pressed
shortly (!) within this countdown.
4. The message SUCCESS which will shortly appear on the "R-Tronic" display,
signalizes that the "teach out" process has been completed successfully and the
radio symbol will no longer be displayed (repeat the "teach out" process if it
was not completed successfully).
► Now the radio communication between the "R-Tronic" and the respective
actuator is interrupted.
5. The message SUCCESS will be replaced by the message TEACH OUT after
about 3 seconds. If further actuators are used, they can also be disconnected
from the "R-Tronic" as described above.
NOTE
The function DELETE PARTICIPANT that is part of the menu INSTALLATION must
only be used if the actuator cannot be "teached out" (for instance no access because
of error or defect). On principle, the radio communication between the "R-Tronic" and
the actuator must only be cancelled via the selection menu TEACH OUT.

5.4.2 Date and time

Each time the "R-Tronic" will be energized, the setting routine for the date (year,
month, day) and the current time (hours, minutes) will be started. This is why these
settings have already been carried out during initial operation and been described
before (see chapter 4.6).
The date and time can be changed subsequently as follows:
1. You are in the submenu SETTINGS. Confirm your selection by pressing the
menu-button. INSTALLATION will be displayed as before.
2. Turn the menu-button slightly to the right and confirm the selection DATE/TIME.
3. Set the date first and then the time. The message SAVED will confirm your
entries.
► Date and time are re-adjusted now.
- 45 von 64 -
Operating