Adaptation Of The "Aktor Mh/Md Con B" To The "R-Tronic - oventrop R-Tronic RT B Installation And Operating Instructions Manual

4.6.2 Adaptation of the "Aktor MH/MD CON B" to the "R-Tronic"

1. Go to the main menu by pressing the menu-button for at least 1 second, until
TIME PROFILE will be displayed.
2. Turn the menu-button to the right until SETTINGS will be indicated on the
display.
3. Press the menu-button. INSTALLATION will be displayed.
4. Press the menu-button again. TEACH IN will appear on the display.
Press the menu button again to start the "teach in" process. A running
countdown of 30 seconds will be displayed.
5. Now the "teach in"/adjustment button at the actuator has to be pressed
quickly (!) within this countdown. As there is normally a distance of several
meters between the radiator or the actuator and "R-Tronic", this should be done
by a second person. This also enables you to keep an eye on the display.
"Teach in"/adjustment button
6. The message SUCCESS which shortly appears on the "R-Tronic" display,
signalizes that the "teach in" process has been completed successfully and the
following radio symbol will be displayed:
Wenn dr
►The radio communication between the operating unit and the actuator is created.
7. After about 3 seconds, the message SUCCESS will be replaced by the message
TEACH IN. If further actuators are used (a maximum of 8 is possible), they can
also be connected to the operating unit via radio as described above. Confirm the
selection TEACH IN by pressing the menu-button once and the next "teach in"
process starts with the countdown.
Installation and initial operation
- 22 von 64 -
(Illustr. 14)