Setting Of The Required Temperature Via Nominal Setting - oventrop R-Tronic RT B Installation And Operating Instructions Manual

4.9.2 Setting of the required temperature via NOMINAL SETTING

The room temperature cannot only be set via PROFILE ON, PROFILE OFF and
PROFILE DAY / NIGHT but also via a direct nominal setting.
NOTE regarding the effectiveness of set values
An active heating profile will be influenced by the nominal setting for a short time. If a
heating profile with different heating and setback phases is active, the selected
temperature (nominal value) will only be effective until the next cycle change.
The same applies for cycle changes in the sequence of programmed individual
profiles (see chapter 5).
If the standard heating profile PROFILE OFF is active, the nominal value can only be
set to a maximum of 17°C.
The required temperature for your rooms can thus be set directly via the setting SET
VALUE. Please proceed as follows:
1. Press the menu button. The following display will appear:
Menu-button
2. Select the required room temperature by turning the menu-button and confirm
your selection by pressing the menu-button once. The message SAVED will be
displayed.
► The required room temperature is set now and the radiator will heat according to
the new setting.
Installation and initial operation
- 31 von 64 -
(Illustr. 27)