Installation And Initial Operation; Wall Attachment Of Fixing Plate With Flush-Mounted Power Pack - oventrop i-Tronic TFC Installation And Operating Instructions Manual

„i-Tronic TFC"
3.

Installation and initial operation

3.1 Wall attachment of fixing plate with flush-mounted
power pack
WARNING
Risk of electric shock!
As the flush-mounted power pack has to be connected to the
current supply of the building, there is a risk of electric shock.
 Installation of the flush-mounted power pack must only be
carried out by a qualified electrician.
 The following 5 safety regulations must be observed:
Disconnect; protect against accidental restart;
check that no voltage is present; earth and short-circuit;
cover adjacent, live parts.
1. Switch off current supply before installation of the flush-mounted
power pack.
2. Provide the electrical connection between the flush-mounted power
pack and the 230 V connection in the flush socket.
3. Screw the fixing plate to the flush socket and switch on current supply.
4. Insert the "i-Tronic TFC" into the fixing plate from the top.
Fixing plate
2
Secondary cable
The flush-mounted power pack has to be in-
stalled so that the primary wires (1) and the
secondary wire (2) do not touch each other. If
necessary, these cables are to be fixed, for in-
stance with a cable retainer in order to guarantee
the physical separation.
The power supply is connected and the "i-Tronic TFC" is ready for use.
X
Flush-mounted
Flush socket
power pack
1
Primary cables 230 V
Installation and initial operation
„i-Tronic TFC"
19