Commissioning; Adaptation; Installing The App; Installation On The Radiator - oventrop mote 200 Operating Instructions Manual

„mote 200"
6.2

Installation on the radiator

The "mote 200" can be fitted to any valve body with
an M 30 x 1.5 connection thread.
Illust. 4: Fitting the "mote 200"
(1)
Valve
(2) Adapter (OPTIONAL!)
(3) "mote 200"
1. Turn the old radiator thermostat to fully open posi-
tion.
2. Loosen the fixing device and remove the old radia-
tor thermostat from the valve.
3. If required, select a suitable adapter for the "mote
200" (see Illust. 2 on page 8 and Illust. 4) and fit
it to the radiator.
4. Fit the "mote 200" to the valve and/or adapter by
turning the collar nut clockwise..
115096180#EN-V04.01.2020
1 2 3
7.

Commissioning

You may start the adaptation run once installation of
the wireless thermostat has been completed.
7.1

Adaptation

Initially calibrate the valve stroke in the "mote 200".
To this end, it is essential to launch an adaptation
process after installation.
Ensure that the "Installation/Removal" function
is active ( flashes).
f Press and hold the "OK/SET"
seconds.
Z The adaptation process starts. The "mote 200"
adapts to the stroke of your valve. The LEDs flash in
sequence.
Once the adaptation process is complete, the prod-
uct switches to control operation. The LEDs indicate
the nominal temperature.
After approx. 5 seconds, the "mote 200" switches to
standby mode. All LEDs are switched off in standby
mode.
7.2

Installing the app

To enter time profiles, connect the "mote 200" using
a smartphone via the Bluetooth interface.
Apps for iOS and Android operating systems are
available in the relevant app stores (iTunes, Google
Play).
f Install the appropriate "mote 200" app for the oper-
ating system you are using. Follow the information in
the applicable installation guide.
- Activate the location request for the „mote
200" app.
- The connection via app can be established
when all LEDs at the „mote 200" are off.
Commissioning
key for approx. 3
9