Operation; Setting Levels Diagram - Omron E5 C Series Manual

E5@C/E5@C-T

Operation

Setting Levels Diagram

E5C
This diagram shows all of the setting levels. To move to the advanced function setting level and calibration level, you must enter passwords. Some
parameters are not displayed depending on the protect level setting and the conditions of use.
Control stops when you move from the operation level to the initial setting level.
Manual Control
Used to set the MV
manually.
*1. Set the PF Setting parameter to a-m (Auto/Manual).
*2. The No. 1 display will flash when the keys are pressed for 1 s or longer.
*3. Set the PF Setting parameter to pfdp (monitor/setting items).
114
Only when Manual Mode was used
just before power OFF
Press the O Key
for at least 1 s or
the S Key for at Level changes
*1
automatically.
least 1 s
Level
O Key for at
least 3 s while
a-m is
*2
displayed.
*1
S Key for at least 1 s
Press the O Key
for at least 1 s.
Initial Setting Level
Used to set the input type
and other basic settings.
Release protection and
then enter the password
(−169) for the amoV
(Move to Advanced
Advanced Function
Setting Level)
parameter.
Used to set application functions.
Enter the password (1201)
while cmov (Move to
Calibration Level
parameter) is displayed.
Press the O + M Keys for
at least 1 s
Power ON
Press the O Key once.
Operation Level
Used for SP, alarm
values, and other basic
settings and monitoring.
*3
Press the S Key.
Press the O Key for
*2
at least 3 s
Control and auxiliary outputs stop.
Press the O Key for less than 1 s.
(models with communications only).
Press the O Key for at least 1 s.
Setting Level
Calibration Level
Protect Level
Used to set protection
for operations.
Press the O + M
Keys for at least 3 s.
Adjustment Level
Used to change adjustment
parameters (PID constants,
adjustment sensitivity, etc.).
*3
Press the S Key.
Monitor/Setting
Item Level
Used to display
specified monitor
and setting items.
Communications
Setting Level
Used to set up
communications.
*2