Operation - Omron E5 J Series Manual

E5 J

Operation

NOTICE:
Always turn off the power supply to the Temperature Controller before changing any switch settings.
Settings
E5CJ
Remove the internal mechanism from the housing. Pull out the inter-
nal mechanism while pressing the hook at the bottom of the front
panel.
Internal Switches
E5CJ
Top View
Note: A model with no alarm does not incorporate
an alarm mode selector.
Bottom View
E5AJ/E5BJ/E5EJ
1. Remove the internal mechanism from the housing. Pull out
the internal mechanism while pressing the hook at the bottom
of the front panel.
Hook
Alarm mode selector 2
(ALM2) (see note)
Alarm mode selector 1
(ALM1) (see note)
Input type selector
(INPUT)
Key protection switch
(PROTECT)
Function selector
(FUNCTION)
Pull out the internal mechanism
while holding down the hook with
your finger.
When inserting the internal
mechanism back into the case,
push the internal mechanism into
the case until it clicks into place.
2. Connect a Control Output Unit to the vacant socket on the
printed circuit board as shown below.
To remove a Control Output Unit, push it up with the tip of a flat-blade
screwdriver as shown below.
Internal Switches
E5AJ
Top View
Bottom View
E5 J
Mount the Control Output Unit
with the mark facing the direc-
tion indicated by the arrow.
Be sure to secure the output
unit with the provided fixture.
Flat-blade
screwdriver
Alarm mode selector 2
(ALM2)
Alarm mode selector 1
(ALM1)
Key protection switch
(PROTECT)
Input type selector
(INPUT)
Function selector
(FUNCTION)
7