Omron E5 C Series Manual page 12

E5GC
Terminal Block Appearance
E5GC-@6
Controllers with Screw Terminal Blocks (M3 Screws)
Wires:AWG24 to AWG18 (equal to a cross-sectional area of 0.21 to 0.82 mm
Note: Refer to Precautions When Wiring E5GC (Controllers with Screwless Clamp Terminal Blocks) on page 132 for information on wiring
Controllers with screwless clamp terminal blocks.
Nomenclature
E5GC
Temperature unit
Operation indicators
Press O Key once to go to Adjustment Level.
Press O Key for at least 3 seconds
to go to the Initial Setting Level.
12
Controllers with Screw Terminal Blocks
• Terminal type: Forked or round crimped terminals
• Tightening torque for all terminals: 0.43 to 0.58 N·m
5.8 mm max.
5.8 mm max.
Front panel
Use the M Key to change Use S Key to change the
to another parameter. digit (default setting).
E5GC-@C
Controllers with Screwless Clamp Terminal Blocks
2
) braided or solid wires
Left Side View of the E5GC
No. 1 display
PV or specified parameter
No.2 display
SP or specified parameter value
Use the U D Keys to set the parameter.
Controllers with Screwless Clamp Terminals Blocks
• Wire stripping length: 8 to 12 mm
• Ferrules: 8 to 12 mm
0.8 to 1.4 mm
8 to 12 mm 8 to 12 mm
Left-panel
Setup Tool
port
Bottom View of E5GC
Bottom-panel Setup
Tool port