Komatsu PC500LC-10R Shop Manual page 555

30 TESTING AND ADJUSTING
REMARK
• By the settings as shown in the figure, movement of a
person or object can be displayed continuously in the
monitor just like using the rearview mirror up to the
right side of the machine body.
• When setting the camera 2 to "R", the right side of the
machine body can be displayed just like a visual im-
age.
• If 2 or more cameras are installed, be sure to set the
use of them from camera 1 in order.
• The simultaneous display function of 2 images be-
comes enabled when camera 1 and camera 2 are set
for use.
• You cannot switch camera 1 between "Я" and "R".
• After entering selected item on each line with F6, return
the screen to "Default" screen with F5, and the setting
is enabled.
• Unless setting is normally set with this function when
the camera is connected, the graphic mark of camera
is not displayed at F3 in the operator mode. According-
ly, the image of the camera cannot be used.
• When the camera is installed, check that the right and left portions of the displayed image are correct.
METHOD FOR OPERATING TESTING MENU (AUTO IDLE STOP TIME FIXING)
Default setting menu is used to check or change default values of the machine monitor and the machine.
"Auto Idle Stop Timer Fixing" function is used to set the time selectable on auto idle stop time setting in the oper-
ator mode.
1.
Select "Default" on "Service Menu" screen.
REMARK
See "METHOD FOR OPERATING SERVICE MODE" in
"SERVICE MODE" for selecting method.
2.
Select "Auto Idle Stop Time Fixing" with the function
switches or numeral input switches on "Default" screen.
REMARK
See "METHOD FOR OPERATING SERVICE MODE" in
"SERVICE MODE" for selecting method.
PC500LC-10R
SET AND OPERATE MACHINE MONITOR
30-149