Komatsu PC500LC-10R Shop Manual page 515

30 TESTING AND ADJUSTING
1.
Adjust the stay (1).
Mounting position (2): 360 mm {14.2 in}
Mounting angle (3): 93 °
2.
Adjust the mirror (4).
Tightening torque of mounting bolt (5):6.0 to 7.0 Nm {0.61 to 0.71 kgm,4.41 to 5.14 lbft}
Mounting position (6): 85 mm {3.3 in}
Mounting angle (7): 27 °
Mounting angle (8): 9 °
Install the mirror so that its KOMATSU logo is at the right side of the machine body.
NOTICE
• Tighten the right and left bolts of each bracket al-
ternately so that their right and left clearances (R)
and (L) become equal.
• If the mirror and stay mounting bolts are tightened
excessively, the bracket will be damaged. Tighten
the bolts to the specified torque.
Adjust the mirror so that the side of the machine is reflected in
it as shown in the figure.
PC500LC-10R
METHOD FOR ADJUSTING MIRRORS
30-109