Komatsu PC500LC-10R Shop Manual page 552

SET AND OPERATE MACHINE MONITOR
3.
Select the unit to be set with the function switches on
"Unit" screen.
F3: Moves the selection downward.
F4: Moves the selection upward.
F5: Selection is canceled. The screen returns to "Default"
screen.
F6: Selection is entered. The screen returns to "Default"
screen.
REMARK
Default value at the shipment is SI Unit.
METHOD FOR SETTING DEFAULT (WITH/WITHOUT ATTACHMENT)
Default setting menu is used to check or change default values of the machine monitor and the machine.
Use the sub menu of "With/Without Attachment" function to configure attachment setting when the attachment is
installed or removed.
1.
Select "Default" on "Service Menu" screen.
REMARK
See "METHOD FOR OPERATING SERVICE MODE" in
"SERVICE MODE" for selecting method.
2.
On the "Default" screen, select "With/Without Attachment"
with function switches or numeral input switches.
REMARK
See "METHOD FOR OPERATING SERVICE MODE" in
"SERVICE MODE" for selecting method.
3.
Select a setting on "With/Without Attachment" screen with
the function switch.
Without attachment: When attachment is not installed
With attachment: When attachment is installed
F3: Moves the selection downward.
F4: Moves the selection upward.
F5: Selection is canceled. The screen returns to "Default"
screen.
F6: Selection is entered. The screen returns to "Default"
screen.
NOTICE
Select "With attachment" on this screen when attachment is installed. The attachment will not be
available in "Working Mode" in operator mode if it is not set on this screen. It results in that the
attachment does not function well or a failure may occur in the hydraulic components.
30-146
30 TESTING AND ADJUSTING
PC500LC-10R