Attaching A Module - Viavi OneExpert DSL User Manual

Attaching a module

The following procedure describes how to attach a module.
To attach a module
1 Position the module so that the connectors on the module line up
with the connectors on the back of the base unit. If correctly posi-
tioned, the four screws also line up.
2 Gently push the module to mate the connectors.
3 To tighten the four screws:
a
b
The module is connected.
November 2015
Tighten by hand until the housing and screw contact each other.
Turn the fastener one complete turn, using a screwdriver or a
coin.
OneExpert DSL User's Guide
22052280, Rev 006
Chapter 1 Introduction
Attaching or removing a module
Page 9