Specifying Test Settings; Loading A Test Profile - Viavi OneExpert DSL User Manual

2 Select the test mode.
– Single DSL (one pair) (available on both Annex A/B and Annex A
Bonded modem)
– Bonded DSL (two pairs) (only available on Annex A Bonded
modem)
The Connection Details menu appears.
3 Specify test settings. See
CAUTION:
The modem has an exposed heat sink on the back of the instru-
ment that must maintain unobstructed contact with ambient air. If
the heat sink is blocked in any way it can become extremely hot,
and modem performance can suffer. It is recommended that the
unit not be operated flat on its back (heat sink down) in any DSL
mode, for more than 15 minutes.

Specifying test settings

Before you begin testing, make sure the test settings on the
OneExpert DSL match the settings of the line that you are testing.
• To access the setup screen, select the Tests & Settings system key
or use the tray menu (swipe down from the top or press the tray
system key).

Loading a test profile

If you have previously specified the settings and saved the test profile, you
can load that profile so you don't have to specify all of the settings again.
November 2015
"Specifying test settings" on page
OneExpert DSL User's Guide
22052280, Rev 006
Chapter 4 TrueSpeed DSL Testing

Specifying test settings

57.
Page 57