Connecting To The Line; Monitoring The Hpna Network; Testing The Hpna Network - Viavi OneExpert DSL User Manual

Connecting to the line

After specifying the test settings, you can connect to the line.
To connect to the line
1 Connect one end of an Ethernet cable to the Ethernet jack on the
right side of the unit.
2 Connect the other end of the cable to the Ethernet port of the CPE
that is on the HPNA network (such as a set-top-box or residential
gateway).

Monitoring the HPNA network

The following procedure describes how to monitor the HPNA network.
To monitor the HPNA network
1 On the Main Menu, select HPNA.
The Station List screen appears. See
2 If desired, use the arrow keys to highlight a specific node and then
press the OK key to view more detailed statistics for that node.

Testing the HPNA network

This test verifies that all installed devices are operating correctly.
To test the HPNA network
1 On the Main Menu, select HPNA.
A list of HPNA nodes appears.
November 2015
OneExpert DSL User's Guide
22052280, Rev 006
Chapter 10 HPNA Testing
Connecting to the line
"Node list" on page 205.
Page 131