Testing Ftp Throughput - Viavi OneExpert DSL User Manual

4 Touch the Settings button and then specify the Ping Test settings.
a
b
c
d
5 Use the Tray menu to save the results.
page 49
The ping test is complete.

Testing FTP throughput

Using the FTP test, you can perform a file transfer to test the throughput of
the circuit.
To test throughput
1 If you haven't done so, specify the settings for the DSL or Ethernet
interface and then connect to the line.
2 Select the Tests & Settings system key.
3 Touch FTP.
4 Touch the Settings button and then specify the Transfer Type,
Concurrent Transfers, Repeat Transfer Count, Download
Protocol, Download URL, Download Username, Download Pass-
word, and HTTP Auth Type.
5 Touch the Results button.
The File Transfer Results appear on the screen.
November 2015
Select Destination Type and then select IPv4 Address, IPv6
Address, or DNS Name.
Enter the Destination IP address or DNS name.
Specify the Transmit Count (how many total ping packets to
send), Transmit Interval (amount of time between packet trans-
mittals), and Transmit Size (how many ping messages are in
each packet).
Touch the Results button.
or "Saving a report" on page
OneExpert DSL User's Guide
See"Saving a report" on
49.
22052280, Rev 006
Chapter 5 Data Testing
Testing FTP throughput
Page 69