Table of Contents
Advertisement
Chapter 9 Wifi Tests
Running Receiver Diagnostics
2
To see a graph of the channels, select the Channel Graph soft key.
3
To see a graph of signal strength over time, select the Time Graph
soft key.
Running Receiver Diagnostics
If your unit is optioned and equipped to do so, the Receiver Diagnostics
modes allow connection from a mobile device through the OneExpert DSL
to the receiver for running a diagnostics application, such as MotoPLYR™.
In this setup, the OneExpert DSL is providing a network bridge between the
802.11 interface and the Ethernet interface.
To run receiver diagnostics
1
Connect the OneExpert DSL to the receiver using an Ethernet cable.
2
From the Wifi menu, select Receiver Diagnostics.
3
Specify the manufacturer of the receiver: Motorola, Cisco, Other.
If you select Other, enter the mobile device IP address.
4
Configure the mobile device's Wifi connection, and then wait for a
wireless connection to be established between the OneExpert DSL
and the mobile device. You must enter "jdsu" in the Client ID field for
the Wifi connection in order for the mobile device to receive the
correct IP address to run the diagnostic application.
5
Run the diagnostics application from the mobile device.
The receiver can now be power cycled per the receiver instructions to
initialize the file transfer.
Page 122
OneExpert DSL User's Guide
22052280, Rev 006
November 2015
Advertisement
Table of Contents
Troubleshooting
