Bt-Only Features - Datalogic Gryphon I GD4132 Product Reference Manual

BT-Only Features

BT Pin Code
This option specifies the pin code (either 4- or 16-characters) to be used for
authentication of the BT
To set the pin code:
1.
2.
3.
4.
5.
6.
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Table 47. BT Pin Code Setting Examples
STEP ACTION
1 Desired Setting
Convert the characters to
2
hexadecimal
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SET BT PIN CODE
Scan 8 or 32
Alphanumeric Characters
5
From Appendix D,
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
link.
Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode, then enable "BT Security Mode" on
Specify the desired pin code length (4 or 16) by scanning the appropriate
bar code in "Select PIN Code Length" on
Determine the desired characters. For example, D254 or
TOR12345678135M
Convert the characters to hexadecimal using the ASCII Chart on the inside
back cover of this manual.
Go to page 279 and Scan the bar code: SET 4 CHAR PIN CODE or SET 16-
CHAR PIN CODE.
Scan the appropriate alphanumeric characters from the keypad in
dix D, Keypad, representing the hexadecimal entries determined in the
steps above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
Changing the pin code setting will unlink the devices. If the Automatic Configu-
ration Update is set to the default enabled setting, the devices must only be
relinked. If the Automatic Configuration Update is set to the disabled setting,
the Pin Code setting must also be updated in the Base Station using Aladdin.
After the Base Station has been updated, the devices must be relinked.
EXAMPLES
D254
44 32 35 34
44323534
page
page 279.
STOR12345678135M
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
53544F5231323334353637383133354D
RF Features
278.
Appen-
313