Datalogic Gryphon I GD4132 Product Reference Manual page 297

5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Prog Mode.
Set Length 2
This feature allows you to set one of the barcode lengths for the specified sym-
bology. Length 2 is the maximum label length if in
second fixed length if in
bology for parameters.
The length that can be set varies depending on the symbology. A setting of 0
specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length (from 1 to 50 — or 0 to ignore this
2. Go to the Set Length page for your selected symbology and scan the
3. Scan the barcode to SELECT LENGTH 2 SETTING for your selected symbol-
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure.
Product Reference Guide
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the begin-
ning.
Fixed Length
length). Pad the number with leading zeroes to yield two digits. For exam-
ple: 0 = 00, 5 = 05, 20 = 20, etc.
ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
ogy.
that represent the length setting which was determined in the steps above.
You will hear a two-beep indication after the last character.
If you make a mistake, before the last character scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
Variable Length
Mode. See the page for the specific sym-
Appendix D, Keypad
Symbologies
Mode, or the
295