Stand Mode Sensitivity; Stand Mode Sensitivity; Scanning Active Time; Scanning Active Time - Datalogic Gryphon I GD4132 Product Reference Manual

Stand Mode Sensitivity

Sets the sensitivity level for stand mode wakeup. Choices are low, medium and
high.
Stand Mode Sensitivity = Medium

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See
feature
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
DEFAULT
108
ENTER/EXIT PROGRAMMING MODE
page 307 in "References" for descriptions of each
005 = Scanning is active for 5 Seconds
Gryphon™ I GD4132/GM4102/GBT4102
Stand Mode Sensitivity = Low
DEFAULT
Stand Mode Sensitivity = High
CANCEL