Global Prefix/Suffix - Datalogic Gryphon I GD4132 Product Reference Manual

Global Prefix/Suffix

Up to 20 ASCII characters may be added as a prefix (in a position before the
barcode data) and/or as a suffix (in a position following the barcode data) as
indicated in Figure 16.
Figure 16. Prefix and Suffix Positions
Example: Setting a Prefix
In this example, we'll set a prefix for all symbologies.
1. Determine which ASCII character(s) are to be added to scanned barcode
2. Go to
3. Scan the SET GLOBAL PREFIX barcode.
4. Reference the
5. If less than the expected string of 20 characters are selected, scan the
6. Scan the ENTER/EXIT barcode once again to exit Programming Mode.
7. The resulting message string would appear as follows:
Scanned barcode
Resulting message string output:
Product Reference Guide
Prefix Label ID AIM ID
data. In this example, we'll add a dollar sign ('$') as a prefix.
page 80 and scan the ENTER/EXIT PROGRAMMING MODE barcode.
ASCII Chart
the hex value assigned to the desired character. The corresponding hex
number for the '$' character is 24. To enter this selection code, scan the
'2' and '4' barcodes from
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
ENTER/EXIT barcode to terminate the string.
data:12345
OR...
Bar Code Data Label ID
00 - 20 Characters (ASCII)
AND
OR
on the inside back cover of this manual to find
Appendix D, Keypad.
$12345
Data Editing
Suffix
297