Bt-Only Features - Datalogic QuickScan QD24 Series Product Reference Manual

References

BT-Only Features

BT Pin Code
This option specifies the 4-character or 16-character pin code to be used for authentication of
the BT link. To set the pin code:
1. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming Mode, then
enable "BT Security Mode"
2. Specify the desired pin code length (4 or 16) by scanning the appropriate bar code in
"Select PIN Code Length"
3. Determine the desired characters. For example, D254 or
4. Convert the characters to hexadecimal using the
this manual.
5. Go to page 224
6. Scan the appropriate alphanumeric characters from the keypad in
representing the hexadecimal entries determined in the steps above. You will hear a two-
beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
NOTE
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
Changing the pin code setting will unlink the devices. If the Automatic Configuration Update
is set to the default enabled setting, the devices must only be relinked. If the Automatic Con-
figuration Update is set to the disabled setting, the Pin Code setting must also be updated in
NOTE
the Base Station using Aladdin. After the Base Station has been updated, the devices must be
relinked.
Figure 13. BT Pin Code Setting Examples
STEP ACTION
1 Desired Setting
Convert the characters to
2
hexadecimal
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SET BT PIN CODE
Scan 8 or 32 Alphanumeric
5 Characters From
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
264
on page
on page 224.
and Scan the bar code: SET 4 CHAR PIN CODE or SET 16-CHAR PIN CODE.
EXAMPLES
44 32 35 34
44323534
223.
ASCII Chart
D254
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
QuickScan™ I QD24XX/QBT24XX/QM24XX
STOR12345678135M
on the inside back cover of
Appendix D,
STOR12345678135M
53544F5231323334353637383133354D
Keypad,