Intercode Delay - Datalogic Gryphon I GD4132 Product Reference Manual

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The
selectable range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 =
3. Go to
4. Scan the barcode: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
this feature.
Table 37. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
00, 5 = 05, 20 = 20, etc
page 65 and scan the ENTER/EXIT PROGRAMMING MODE barcode to
enter Programming Mode.
that represent the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
No Delay
00
'0' and '0'
Table 37 for some examples of how to set
5 Seconds 60 Seconds
05 60
'0' and '5' '6' and '0'
Keyboard Interface
Appendix D, Keypad,
99 Seconds
99
'9' AND '9'
293