Datalogic Gryphon I GD4132 Product Reference Manual page 314

References
STAR Radio Protocol Timeout
This parameter sets the valid wait time before transmission between the hand-
held reader and Base Station is considered failed.
When setting this parameter, take into consideration the radio traffic (number
of readers in the same area). The selectable range for this feature is from 02 to
25 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 2 =
3. Go to
4. Scan the barcode: SELECT RADIO PROTOCOL TIMEOUT.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
this feature.
Table 46. STAR Radio Protocol Timeout Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCODE DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
312
02, 5 = 05, 25 = 25, etc
page 275 and scanScan the ENTER/EXIT PROGRAMMING MODE bar-
code to enter Programming Mode.
that represent the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
2 Seconds
02
'0' and '2'
Table 46 for some examples of how to set
5 Seconds 10 Seconds
05 10
'0' and '5' '1' and '0'
Gryphon™ I GD4132/GM4102/GBT4102
Appendix D, Keypad,
25 Seconds
25
'2' AND '5'