Good Read Led Duration - Datalogic Gryphon I GD4132 Product Reference Manual

Good Read LED Duration

This feature specifies the amount of time that the Good Read LED remains on
following a good read. The good read LED on time can be set within a range of
10 milliseconds to 2,550 milliseconds (0.001 to 2.55 seconds) in 100ms incre-
ments.
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds. A setting of 0 means that
2. Divide the desired setting by 10 (setting is in 100ms increments). Pad the
3. Go to
4. Scan the barcode: SELECT GOOD READ LED DURATION SETTING.
5. Scan the appropriate three digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
this feature.
Table 41. Good Read LED Duration Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT LABEL GONE TIMEOUT SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
the good read LED stays on until the next time the trigger is pulled.
result with leading zeroes to yield three digits. For example: 0 = 000, 5 =
000, 20 = 020, etc.
page 104 and scan the ENTER/EXIT PROGRAMMING MODE barcode
to enter Programming Mode.
representing the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
Good Read LED
stays on until
next trigger pull
(00)
000
'0', '0' and '0'
Table 41 for some examples of how to set
20ms 150ms
002 015
'0', '0' and '2' '0', '1' and '5'
Reading Parameters
Appendix D, Keypad
2550ms (2.55 sec.)
255
'2', '5' and '5'
305