Reading Parameters; Label Gone Timeout - Datalogic Gryphon I GD4132 Product Reference Manual

References

Reading Parameters

Label Gone Timeout

This feature sets the time after the last label segment is seen before the reader
prepares for a new label. The timeout can be set within a range of 10 millisec-
onds to 2,550 milliseconds (2.55 seconds) in 10ms increments. Label Gone
Timeout does not apply to scan modes that require a trigger pull for each label
that is read
Follow these instructions to set this feature:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the
3. Go to
4. Scan the barcode: SELECT LABEL GONE TIMEOUT SETTING.
5. Scan the appropriate three alpha-numeric characters from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
this feature.
Table 40. Timeout Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2
leading zeroes)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT LABEL GONE TIMEOUT SETTING
Scan Three Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
304
result with leading zeroes to yield three digits. For example: 0 = 000, 5 =
005, 20 = 020, etc.
page 97 and scan the ENTER/EXIT PROGRAMMING MODE barcode to
enter Programming Mode.
Appendix D, Keypad
the steps above. You will hear a two-beep indication after the last charac-
ter.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
50ms
005
'0', '0' and '5'
representing the duration which was determined in
Table 40 for some examples of how to set
150ms
015
'0', '1' and '5'
Gryphon™ I GD4132/GM4102/GBT4102
1800ms (1.8 sec.) 2550ms (2.55 sec.)
180
'1', '8' and '0' ''2', '5' and '5'
255