Intercharacter Delay - Datalogic Gryphon I GD4132 Product Reference Manual

References

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the
3. Go to
4. Scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming
This completes the procedure. See
this feature.
Table 36. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (and pad with
2 leading zeroes to yield two-
digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCHARACTER DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
292
This feature applies ONLY to the Keyboard Wedge interface.
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
page 64 and scan the ENTER/EXIT PROGRAMMING MODE barcode to
enter Programming Mode.
that represent the duration which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar-
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
50ms
05
'0' and '5'
Table 36 for some examples of how to set
150ms 600ms
15 60
'1' and '5' '6' and '0'
Gryphon™ I GD4132/GM4102/GBT4102
Appendix D, Keypad,
850ms
85
'8' and '5'