Bt-Only Features - Datalogic QuickScan I QM21X1 Product Reference Manual

BT-Only Features

BT Pin Code
This option specifies the 4-character or 16-character pin code to be used for
authentication of the BT
1. Scan the
ming Mode, then enable
2. Specify the desired pin code length (4 or 16) by scanning the appropriate
bar code in
3. Determine the desired characters. For example, D254 or
4. Convert the characters to hexadecimal using the
back cover of this manual.
5. Go to
CHAR PIN CODE.
6. Scan the appropriate alphanumeric characters from the keypad in
D,
above. You will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the beginning.
NOTE
7. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
Changing the pin code setting will unlink the devices. If the Automatic Configuration Update
is set to the default enabled setting, the devices must only be relinked. If the Automatic Con-
figuration Update is set to the disabled setting, the Pin Code setting must also be updated in
NOTE
the Base Station using Aladdin. After the Base Station has been updated, the devices must be
relinked.
Figure 11. BT Pin Code Setting Examples
STEP ACTION
1 Desired Setting
Convert the characters to
2
hexadecimal
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SET BT PIN CODE
Scan 8 or 32
Alphanumeric Characters
5
From Appendix D,
Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
308
link.
ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
"Select PIN Code Length"
page 269 and Scan the bar code: SET 4 CHAR PIN CODE or SET 16-
Keypad, representing the hexadecimal entries determined in the steps
EXAMPLES
D254
44 32 35 34
44323534
To set the pin code:
"BT Security Mode" on page
on page 269.
STOR12345678135M
53 54 4F 52 31 32 33 34 35 36 37 38 31 33 35 4D
53544F5231323334353637383133354D
QuickScan™ I QM21X1 / QBT21X1
268.
STOR12345678135M
ASCII Chart on the inside
Appendix